Local Repair FinderAtlanta home repair guide

A leaking water heater in Atlanta

Atlanta, Fulton & DeKalb · Reviewed November 2026 · Checked against 7 public sources

Close the cold-water valve above the tank, then turn off the power (electric) or set the gas control to off (gas). Where the water comes from decides the next step: fittings and valves can often be repaired, but a leak from the tank itself usually means replacement. In Atlanta, replacing a water heater needs a City plumbing permit, and Fixr's national average range for a gas tank-style water heater is $1,000 to $2,700.

Key facts

Step one
Turn off the cold inlet valve above the tank
Step two
Electric: its breaker off. Gas: control knob to off
Replacement permit
City of Atlanta plumbing permit
Gas tank-style, national
$1,000–$2,700 (Fixr)
Rebates
Atlanta Gas Light $200/$300 (2026); Georgia Power 50% of the cost, up to $800, for heat pump models
  1. Shut the inlet. Find the valve on the cold line feeding the top of the heater and turn it closed, so the tank stops refilling as it drips.
  2. Take away the heat source. On an electric model, flip its breaker. On a gas model, set the control knob to off. Any gas odor means you leave the house instead, then phone 911 and Atlanta Gas Light at 877.427.4321 once outside.
  3. Cold supply off and the tank still dripping? Call an Atlanta plumber, and keep going with the steps while you wait.

    Phone line opening soon

    Have this ready when you call

    • Your address
    • Where the water is and whether the main is off
    • When it started
  4. Find the source. Dry the tank and fittings, then watch. A drip at a pipe connection or the drain valve is different from water seeping out of the tank's base.
  5. Look at the relief valve. Water from the pipe running down the tank's side means the pressure relief valve opened. Leave it for the plumber.
  6. Protect the floor. Wet-vac standing water and move stored items. If the tank sits in an attic or upstairs closet, check the ceiling below.
Water pooling in a drain pan around the base of a water heater

Repair or replace?

  • Leaking fitting, drain valve or supply line: often a repair.
  • Relief valve discharging: needs a plumber to find out why.
  • Water from the tank body or a rusted base: the tank is usually done.

If it's being replaced

The City's plumbing permit form lists replacing water heaters as permitted work, completed by a licensed Georgia plumbing contractor or the property's legal owner. Fixr's national average range for a gas tank-style water heater is $1,000 to $2,700. Atlanta Gas Light's 2026 program pays $200 for a whole-house gas storage tank at .82 UEF or higher and $300 for a whole-house tankless unit at .87 UEF or higher. Georgia Power pays 50% of the cost, up to $800, for an ENERGY STAR heat pump water heater. Check the plumber's license with the Division of Master and Journeyman Plumbers on the Georgia Secretary of State license lookup.

What a repair usually costs

National ranges from cost publishers, not Atlanta quotes. The fault decides the price, so ask for it in writing before work starts.

JobNational rangeSource
Water heater repair$150 to $750Fixr, updated Aug 2025

When you call: 4 questions to ask

  1. The City requires a plumbing permit to replace a water heater: will you pull it?
  2. Is this leak on my side of the water meter or the Department of Watershed Management's?
  3. What's your license number with the Division of Master and Journeyman Plumbers?
  4. Would a heat pump water heater or an efficient gas tank qualify for a rebate here?

A fair written quote shows the heater or parts, labor, the permit, removal of the old tank and the written warranty. Check any contractor's license on the Georgia Secretary of State license lookup before work starts.

What happens when you call

  1. You're connectedStraight to a local plumber that serves your area and takes calls like yours.
  2. You get a priceDescribe the problem, ask for a written quote and their license number. No obligation.

Want a price for your home? Call a local plumber for a written quote.

Phone line opening soon

Common questions

My water heater is dripping. What comes first?

Close the cold-water supply valve, then shut off the breaker for an electric heater or turn the gas control off for a gas one. If you smell gas, leave and call 911 and Atlanta Gas Light.

Is a permit needed to swap a water heater inside Atlanta city limits?

Yes. Replacing water heaters is on the City's plumbing permit application.

Which rebates apply to a replacement heater in Atlanta?

Atlanta Gas Light's 2026 program pays $200 for an efficient whole-house gas storage tank and $300 for an efficient whole-house tankless unit; Georgia Power pays 50% of the cost, up to $800, for an ENERGY STAR heat pump water heater.

Related guides

Sources

  1. Atlanta Gas Light: Safety
  2. City of Atlanta Office of Buildings: Plumbing permit application
  3. Fixr: Gas water heater cost
  4. Atlanta Gas Light: 2026 efficiency rebates
  5. Georgia Power: Home Energy Improvement Program preconditions and requirements, 2026
  6. Georgia Secretary of State: About the Division of Master and Journeyman Plumbers
  7. Georgia Secretary of State: License lookup and verification

Costs are typical ranges. Your quote depends on your home. Rules and rebates change; check the original source before you rely on a figure. Something wrong? Tell us via the contact on the Impressum page.