If you smell gas, leave the area immediately, then call 911 and Texas Gas Service at 800-959-5325. Otherwise check the thermostat, the filter, the furnace power switch and the breaker, resetting it once. Leave gas valves and pilot lights alone. Austin's normal January low is 41.8 °F at Camp Mabry, so most nights without heat are uncomfortable, not dangerous, but a hard freeze changes that.
Key facts
- Gas odor
- Leave, then 911 and Texas Gas Service, 800-959-5325
- Try yourself
- Thermostat, filter, power switch, one breaker reset
- Don't touch
- Gas valve, pilot light, burner compartment
- Power out
- Austin Energy, 512-322-9100
- Gas furnace, new
- $3,800–$10,000 installed (national, Fixr)
- Gas company rebate
- None; the Texas Gas Service program has expired
- January normal low
- 41.8 °F, Camp Mabry (NWS 1991-2020)
Safe to wait or not?
| Can wait | Mild weather, no gas odor, no alarm sounding, and everyone at home can manage with blankets or a space heater kept clear of anything that burns. A next-day visit is reasonable. |
|---|---|
| Can't wait | Any smell of gas, a carbon monoxide alarm, a hard freeze in the forecast, or a household member who cannot cope with cold. Get out for gas or an alarm; otherwise call a heating company now. |
Five checks you can do safely
- Use your nose before your hands. A gas odor ends the troubleshooting. Texas Gas Service says to leave the area immediately and then call 911 and Texas Gas Service at 800-959-5325. Separately, if a carbon monoxide alarm sounds, get everyone outside and call 911.
- Thermostat on Heat. After months of cooling it is often still set to Cool or Off. Choose Heat, raise the target above the room reading and replace the batteries if the display is faint.
- Filter. A blocked filter makes a furnace overheat and shut itself down. Fit a clean one, matching the size printed on the old frame.
- Power. Look for a wall switch on or beside the furnace and confirm it is up. Then check the breaker marked Furnace or Air Handler and reset a tripped one a single time; if the whole house is dark, report it to Austin Energy at 512-322-9100.
Heat mode set, filter changed, power on and the air is still cold? Ring a local heating company, then carry on down the list.
Phone line opening soonHave this ready when you call
- Your address
- What the system is doing (no heat, no cooling, a noise, a leak)
- Roughly how old the unit is
- Airflow. Walk the rooms opening supply registers, and pull boxes or furniture away from the return grille. Give the system ten minutes to respond before deciding nothing changed.

When the checks don't fix it
Call a heating company and stop experimenting when:
- The blower runs but the air stays cold.
- The furnace starts, quits after a minute or two and keeps repeating.
- The breaker trips again.
- You hear banging, squealing or a loud rumble at start-up.
- You see soot, scorch marks or water around the cabinet.
Relighting a pilot, turning a gas valve and removing the burner door are all outside what a homeowner should attempt. A technician carries the instruments to test for gas and carbon monoxide.
Cold in a warm-weather city
The January normal low at Camp Mabry is 41.8 °F, taken from the National Weather Service's 1991-2020 normals. Heating gets far less use here than cooling, so a fault can sit unnoticed until the first cold night. Winter Storm Mara in February 2023 is the reminder that real winter does visit: city crews and contractors collected over 170,000 tons of storm debris afterward.
When a freeze is coming and the heat is off, open cabinet doors under sinks and read the frozen pipes page before bed.
Gas company, license and permit
Texas Gas Service delivers natural gas in Austin, and its emergency number is the one above. Heating contractors come under the same state license as AC firms: an air conditioning and refrigeration (ACR) contractor license from the Texas Department of Licensing and Regulation, searchable on the TDLR's license search.
If the furnace has to be replaced, the City lists a residential Mechanical Change Out stand-alone permit for change-out work, applied for by a registered contractor; it doesn't name furnaces, so confirm with the contractor which permit applies, and gas work needs its own permit. The City's emergency permits page adds that no gas work is exempt from a permit.
What replacement runs, and the rebate picture
There is no verified Austin price for a furnace repair in this guide. Fixr's national figure for a new natural gas furnace is $3,800 to $10,000 installed; the furnace cost page goes through it.
Texas Gas Service states that its Energy Efficiency Program has expired and rebate offerings are no longer available. Austin Energy does pay $650, $750 or $950 by tier toward a heat pump, which heats as well as cools, when a participating contractor installs it.
What a repair usually costs
National ranges from cost publishers, not Austin quotes. The fault decides the price, so ask for it in writing before work starts.
| Job | National range | Source |
|---|---|---|
| Furnace repair | $349 to $650 | Fixr, updated Aug 2025 |
When you call: 4 questions to ask
- Are you an Austin Energy participating contractor, and which rebate tier does this heat pump fall in?
- Is the City's mechanical change-out permit in your price?
- Which TDLR air conditioning license do you hold?
- How did you work out the size for this house?
A fair written quote shows the unit and tier, the change-out permit, the Austin Energy rebate paperwork, haul-away and warranty. Check any contractor's license on the TDLR license search before work starts.
What happens when you call
- You're connectedStraight to a local heating & cooling pro that serves your area and takes calls like yours.
- You get a priceDescribe the problem, ask for a written quote and their license number. No obligation.
Want a price for your home? Call a local heating & cooling pro for a written quote.
Phone line opening soonCommon questions
Why is my furnace blowing cold air?
Check that the thermostat says Heat and the fan is on Auto, not On. A clogged filter can also make the burner shut off while the blower keeps going. If both are fine, a technician needs to look.
Who do I call if I smell gas near my furnace in Austin?
Leave the area immediately, then call 911 and Texas Gas Service at 800-959-5325. Wait for the gas company before any heating contractor works on the equipment.
Should I relight the pilot light myself?
This guide's advice is no. Pilot lights and gas valves are left to a licensed technician, who can also find out why the flame went out.
Is there a rebate for a new furnace in Austin?
Not from the gas company at present: Texas Gas Service says its Energy Efficiency Program has expired. Austin Energy's rebates apply to heat pumps, at $650, $750 or $950 depending on tier.
Related guides
Sources
- National Weather Service Austin/San Antonio: January climate sheet, Camp Mabry (Normals 1991-2020)
- Texas Gas Service: Safety
- Texas Gas Service: Central-Gulf Service Area
- Texas Gas Service: Energy Efficiency Program
- Austin Energy: Report outages
- Austin Energy: Air conditioner and heat pump rebates
- Austin Resource Recovery: Winter Storm Mara after action report (2023)
- City of Austin Development Services: Types of permits
- TDLR: Air Conditioning and Refrigeration at a Glance
- TDLR: Active License Search
- Fixr: Furnace replacement cost (national)
Costs are typical ranges. Your quote depends on your home. Rules and rebates change; check the original source before you rely on a figure. Something wrong? Tell us via the contact on the Impressum page.