A breaker trips to protect the wiring, so repeated tripping is information, not a nuisance to override. Unplug everything on the circuit, reset the breaker once, and add devices back one by one. If it holds until a particular appliance goes on, you have found an overload. If it trips with nothing connected, or you notice heat, buzzing or a burnt smell, leave it off and call an electrician.

Key facts
- Is this an emergency?
- Yes with a burning smell, a hot or scorched outlet, buzzing or sparks. Otherwise no.
- Can I sort it myself?
- You can test for an overloaded circuit. You should not open the panel cover or keep resetting.
- Who do I need?
- An electrician licensed through TDLR; Oncor if the whole house is out.
Is this an emergency?
Use your nose and your hand. A sharp, hot-plastic odor, an outlet or switch plate that is warm or discolored, crackling from inside a wall or from the breaker box: any of these means leave that breaker off and get an electrician out. Visible smoke or flame is a 911 call. A breaker that drops when the microwave and the kettle run together, with none of those signs, is a circuit doing its job.
Can I sort it myself?
You can run one clean test. The panel's front cover stays screwed on throughout; you only touch the breaker handles.
- Identify the circuit. Note which handle is out of line and which rooms went dead.
- Unplug it all. Every lamp, charger and appliance on those outlets; switch lights off.
- Reset once. Push the handle firmly to Off, then to On.
- Reconnect one at a time. Leave a minute between items. The device that makes it trip is your suspect; so is the moment when two heavy users run together.
- Spread the load. Space heaters, hair dryers, microwaves and window units belong on different circuits where you can manage it.
- Test-button outlets. In kitchens, baths, garages and outdoors, a dead outlet may just need its Reset button pressed. Try it once.
Stop and call a pro when
- the breaker trips with nothing plugged in;
- it trips again the instant you reset it;
- the handle feels loose or will not latch;
- the panel is warm, hums or smells;
- lights dim or flicker across several rooms;
- the same appliance trips any circuit you move it to (retire the appliance, too).
Want a price for your home? Call a local electrician for a written quote.
Phone line opening soonWho do I need?
An electrician. The Texas Department of Licensing and Regulation oversees electrician licensing, and its TDLR License Data Search covers electricians as well as AC contractors. The City's Building Inspection FAQ says electrical work must be performed by a licensed electrician unless the homeowner can prove to the Chief Electrical Inspector that they have the knowledge and expertise to do it; the homestead exemption it describes covers plumbing and mechanical work. The FAQ also says permits are required for electrical work unless Chapter 52 of the Dallas Building Code exempts it.
If every circuit is dead and the neighbors are dark, the fault is not in your house. Oncor Electric Delivery handles outages at 888.313.4747. You buy the electricity from a retail provider, but lines and outages are Oncor's.
There is no verified Dallas price in this guide for tracing a fault or replacing a breaker; the table below gives a national range for replacing one. Where the diagnosis is an undersized service, Fixr's national figure for upgrading to 200 amp service is $1,800 to $4,500; see panel upgrade cost.
Dallas details
| Item | What applies in Dallas |
|---|---|
| License to ask for | Texas electrician license (TDLR) |
| Who may do the work | City FAQ: electrical work must be done by a licensed electrician unless the homeowner can show the Chief Electrical Inspector they have the knowledge and expertise to do it |
| Permit | City FAQ: required for electrical work unless Chapter 52 exempts it |
| Permit office | Permit Service Center, Oak Cliff Municipal Center, 320 E. Jefferson Blvd., Room 118, Dallas, TX 75203; (214) 948-4480 |
| Whole-house outage | Oncor Electric Delivery, 888.313.4747 |
| 200 amp service upgrade | $1,800 to $4,500 (national, Fixr) |
| Diagnosis or breaker replacement | No local figure; national breaker range below |
What a repair usually costs
National ranges from cost publishers, not Dallas quotes. The fault decides the price, so ask for it in writing before work starts.
| Job | National range | Source |
|---|---|---|
| Replacing a circuit breaker | $100 to $260 | HomeGuide |
When you call: 4 questions to ask
- What's your TDLR electrical license number?
- Who applies for the City of Dallas electrical permit for the panel work?
- Will the new panel have spare room for a heat pump or car charger?
- Is there a trip charge, and does it come off the job?
A fair written quote shows the panel or parts, labor, the permit and inspection, and extra wiring repairs listed separately. Check any contractor's license on the TDLR license search before work starts.
What happens when you call
- You're connectedStraight to a local electrician that serves your area and takes calls like yours.
- You get a priceDescribe the problem, ask for a written quote and their license number. No obligation.
Common questions
Why does my breaker keep tripping?
The usual causes are too many high-draw devices on one circuit, a faulty appliance, or a wiring fault. The unplug-and-reset test separates the first two from the third.
Is it safe to keep resetting a tripped breaker?
Reset it once as a test. A breaker that trips again is telling you something is wrong, so leave it off and call an electrician.
Can I replace a breaker myself in Dallas?
The City's FAQ says electrical work must be performed by a licensed electrician (with a narrow homeowner exception) and that permits are required for electrical work unless Chapter 52 of the Dallas Building Code exempts it; replacing or adding a panel needs an electrical permit.
Who do I call when the power is out in Dallas?
Oncor Electric Delivery at 888.313.4747 for an outage. For a single dead circuit in your home, call an electrician.
Related guides
Sources
- TDLR: Electricians
- TDLR: License Data Search
- City of Dallas: Building Inspection FAQs
- City of Dallas: Service First Bulletin #204
- City of Dallas: Planning & Development Guide
- City of Dallas: Building Inspection contacts and locations
- Oncor: Storm center update, Dallas County restoration
- Oncor: Outage FAQs
- Fixr: Electrical panel upgrade cost
Costs are typical ranges. Your quote depends on your home. Rules and rebates change; check the original source before you rely on a figure. Something wrong? Tell us via the contact on the Impressum page.