Local Repair FinderDenver home repair guide

Water heater leaking in Denver

Denver & the metro area · Reviewed November 2026 · Checked against 9 public sources

Close the cold-water valve above the heater so the tank stops refilling, and switch off the breaker if the heater is electric. Then look for where the water starts: a fitting on top is often repairable, while water from the tank body means replacement. Colorado's State Plumbing Board says replacing a water heater takes a licensed plumber. Fixr's national range for a tank-style gas unit is $1,000 to $2,700.

Key facts

1. Water
Close the cold inlet valve above the heater
2. Power
Electric heater: breaker off. Gas heater: leave the gas controls alone
Gas odor
Leave, then Xcel Energy 1-800-895-2999; 911 if life-threatening
Who may replace it
A licensed plumber working for a registered plumbing contractor (State Plumbing Board)
New tank-style gas heater
$1,000–$2,700 installed in an existing gas setup (national, Fixr)
Heat pump water heater (2026)
Xcel Energy: $750 standard, $1,500 with the bonus
Can't stop the water
Denver Water 303-893-2444 weekdays 7:30 a.m.-5:30 p.m.; 303-628-6801 after hours

Rule out the simple things

  1. Turn the handle on the cold pipe above the heater: that valve feeds the tank, and closing it keeps a leaking tank from topping itself up indefinitely.
  2. Flip the breaker off for an electric heater: heating elements burn out fast once the water level falls below them.
  3. Cold supply closed and the heater's power dealt with? Call a local plumber at this point, then go on down the list.

    Phone line opening soon

    Have this ready when you call

    • Your address
    • Where the water is and whether the main is off
    • When it started
  4. Keep your hands off the gas control on a gas heater: adjusting gas parts is not a homeowner check, and the plumber will shut it down properly.
  5. Close the house main if the small valve will not budge: an old valve that is seized or weeping is common, and the main does the same job for the whole house.
  6. Dry the top of the tank and watch the pipe connections: a bead of water forming at a fitting points to a repair, not a dead heater.
  7. Look at the pipe that runs down the side from the relief valve: water from that pipe means the safety valve is opening, which a plumber needs to hear about.
  8. Check the floor right at the base: water seeping from under the jacket with dry fittings above usually means the tank itself has failed.
  9. Move boxes and rugs and take photos: stored items soak up water quickly, and pictures of the source help with both the quote and any claim.
Water pooling in a drain pan around the base of a water heater

Signs it is not simple

  • Water is coming from the tank body or from underneath, with the fittings on top dry.
  • The relief valve pipe is running steadily or spitting hot water.
  • You smell gas near the heater. Leave the house before doing anything else.
  • There are scorch marks, soot or melted plastic around the burner area or the wiring.
  • The supply valve and the main are both closed and water keeps appearing.
  • Water has reached drywall, carpet or a finished room below.

A tank that has rusted through cannot be patched. From here the job is draining, disconnecting and replacing, and in Colorado that is licensed work.

Who does what in Denver

A licensed plumber replaces the heater. In a December 2025 bulletin, the Colorado State Plumbing Board reminded licensees that water heater installations or replacements in Colorado require a licensed plumber working for a registered plumbing contractor, along with permits and inspections. Search the plumber's name on the DORA license lookup that the board links from its own site.

Denver issues the permit. The city's quick permits page lists water heaters under both its mechanical and plumbing headings for single-family and duplex homes, so the permit comes without plan review. Ask the plumber to show the permit as a line on the estimate.

Xcel Energy answers gas odor calls. Its instructions are to leave home immediately and not to operate any electrical device, garage door opener or phone until you are outside and away. Then call Xcel Energy at 1-800-895-2999, and call 911.

Denver Water stops at the street side. The utility states that it is not responsible for water damage caused by a property's service line or internal plumbing. Its emergency lines, 303-893-2444 during weekday business hours and 303-628-6801 after hours, are for leaks, main breaks and emergency service problems, and they are worth knowing if you cannot shut the water off. Customers of another provider should use the number on their bill.

Prices and rebates. Fixr's national range for a standard tank-style gas water heater installed in an existing gas setup is $1,000 to $2,700; it does not cover tankless units, and this guide has no Denver figure. Xcel Energy's 2026 rebate summary lists $750 standard, or $1,500 with the bonus, for an ENERGY STAR heat pump water heater. Under the Colorado Heat Pump Tax Credit the installing contractor claims $250 for a heat pump water heater and passes on a discount of at least $83. See the replacement cost page.

A water damage company dries the house. If the leak ran for hours before anyone noticed, follow water damage: the first steps once the plumber is on the way.

What a repair usually costs

National ranges from cost publishers, not Denver quotes. The fault decides the price, so ask for it in writing before work starts.

JobNational rangeSource
Water heater repair$150 to $750Fixr, updated Aug 2025

When you call: 4 questions to ask

  1. Does a licensed plumber do the water heater work, as the State Plumbing Board requires?
  2. Is the city permit and inspection in the price?
  3. What's the trip charge, and does it count toward the repair?
  4. Would a heat pump water heater qualify for an Xcel Energy rebate in my home?

A fair written quote shows parts, labor, permit and inspection, removal of the old unit, and the warranty in writing. Check any contractor's license on the DORA license lookup before work starts.

What happens when you call

  1. You're connectedStraight to a local plumber that serves your area and takes calls like yours.
  2. You get a priceDescribe the problem, ask for a written quote and their license number. No obligation.

Want a price for your home? Call a local plumber for a written quote.

Phone line opening soon

Common questions

Is a leaking water heater an emergency?

A slow drip from a fitting can wait for a normal appointment once the supply is closed. Water from the tank body, a steadily discharging relief valve or any gas smell should be treated as urgent.

Can a leaking water heater be repaired?

Sometimes. Leaks at the pipe connections, the drain valve or the relief valve can often be fixed. A leak from the tank itself means the heater has to be replaced.

Do I need a permit to replace a water heater in Denver?

The Colorado State Plumbing Board says installations and replacements require a licensed plumber, permits and inspections. Denver lists water heaters among the work that can be issued as a quick permit.

How much does a new water heater cost in Denver?

There is no verified Denver figure in this guide. Fixr's national range is $1,000 to $2,700 for a standard tank-style gas unit installed in an existing gas setup.

Related guides

Sources

  1. Colorado State Plumbing Board (DORA): water heater installation bulletin, December 2025
  2. Colorado DORA: License lookup
  3. Denver Community Planning and Development: Quick permits
  4. Xcel Energy newsroom: gas safety and cold weather release, January 2026
  5. Denver Water: Emergencies
  6. Denver Water: Homeowner responsibility
  7. Fixr: Gas water heater cost (national)
  8. Xcel Energy: 2026 Colorado Residential Rebate Summary
  9. Colorado Energy Office: Colorado Heat Pump Tax Credit

Costs are typical ranges. Your quote depends on your home. Rules and rebates change; check the original source before you rely on a figure. Something wrong? Tell us via the contact on the Impressum page.