A breaker trips to protect the wiring. In summer the culprit is often the air conditioner; in winter, a space heater sharing a circuit. Unplug what's on that circuit, reset the breaker once, and add things back one at a time. If it trips with nothing connected, or anything is warm or smells burnt, leave it off and call an electrician licensed by the Oklahoma Construction Industries Board. Oklahoma City issues electrical permits only through a state-licensed, City-registered electrical contractor.

Key facts
- Whole street dark
- OG&E outage: 405-272-9595 (OKC)
- One circuit
- Unplug, reset once, add back one by one
- Trips with nothing on it
- Leave it off; call an electrician
- Warm, buzzing, burnt smell
- Leave it off; call an electrician
- Electrical permit
- Through a state-licensed, City-registered contractor (Sec. 18-36)
- 200-amp service upgrade
- $1,800–$4,500, typical (Fixr, national)
Is it you or OG&E?
If the neighbors are out too, it's not your breaker. Call OG&E at 405-272-9595 in OKC or 800-522-6870 from all other areas.
A methodical reset
- Note which lights and outlets went dead; they share the tripped circuit.
- Unplug everything on it and switch off its lights. Heaters, hair dryers, microwaves and window AC units draw the most.
- At the panel, push the tripped handle firmly to Off, then On. Do this once. Stand to the side and keep your other hand away from the panel.
- Plug things back in one at a time, a minute apart. If one item trips it, that item or its cord is the suspect. If it only trips with two big loads running, the circuit is overloaded.
- Check for a GFCI outlet with a tripped button in kitchens, baths, garages and outside. Press Reset.
Want a price for your home? Call a local electrician for a written quote.
Phone line opening soonSigns that need an electrician
- It trips straight away with nothing plugged in.
- A snap, spark or burning smell at reset.
- A warm, discolored or buzzing breaker, outlet or panel cover.
- The main breaker trips, or lights dim across the house when the AC kicks on.
- The AC or furnace circuit trips during a heat wave or a freeze: treat that as urgent. See AC not cooling or furnace not working.
Never tape a breaker on, hold it in place, or swap in a bigger one.
Fixes, permits and price
Oklahoma City's Electrical Code requires permits for any interior or exterior electrical wiring or electrical construction, issued through a state-licensed, City-registered electrical contractor (Sec. 18-36). That means a new circuit or a panel change is a job for a contractor who can take out the permit. Check the license on the CIB's Are They Licensed? page. If the electrician recommends a service upgrade, Fixr's cost table says upgrading to 200-amp service typically costs $1,800 to $4,500 nationally; see the panel upgrade page.
What a repair usually costs
National ranges from cost publishers, not Oklahoma City quotes. The fault decides the price, so ask for it in writing before work starts.
| Job | National range | Source |
|---|---|---|
| Replacing a circuit breaker | $100 to $260 | HomeGuide |
When you call: 4 questions to ask
- Are you state-licensed and registered with the City, so you can take out the permit?
- Does this job need a service release from OG&E, and will you arrange it?
- Will the panel have room for future circuits?
- Is the trip charge credited on the job?
A fair written quote shows the panel or circuit work, labor, the permit and any OG&E coordination, each listed. Check any contractor's license on the CIB license search before work starts.
What happens when you call
- You're connectedStraight to a local electrician that serves your area and takes calls like yours.
- You get a priceDescribe the problem, ask for a written quote and their license number. No obligation.
Common questions
Why does my breaker keep tripping?
Usually too much load on one circuit, a faulty appliance or cord, or a wiring fault. If it trips with nothing connected, it's a job for an electrician.
How many times should I reset a tripped breaker?
Once. If it trips again, leave it off and call an electrician.
Can I add a circuit myself in Oklahoma City?
The City issues electrical permits through a state-licensed, City-registered electrical contractor, so new wiring goes through a contractor.
Related guides
Sources
- OG&E: Outage FAQ
- City of Oklahoma City: Electrical Code ordinance, Chapter 18, Secs. 18-36 and 18-37 (effective July 14, 2011)
- Oklahoma Construction Industries Board: Frequently asked questions (last modified Dec 30, 2025)
- Oklahoma Construction Industries Board: Are they licensed?
- Fixr: Electrical panel upgrade cost
Costs are typical ranges. Your quote depends on your home. Rules and rebates change; check the original source before you rely on a figure. Something wrong? Tell us via the contact on the Impressum page.