Unplug what's on the dead circuit, reset the breaker once, and plug things back one at a time. If it trips right away with nothing connected, or you notice heat, burning smells or scorch marks, leave it off and call an electrician. If the panel itself is the problem, upgrading to 200-amp service typically costs $1,800 to $4,500 (Fixr, national).

Key facts
- Reset rule
- Once. Trips again: leave it off
- Burning smell, scorch marks, hot panel
- Stop and call an electrician
- Summer
- Long AC and heat pump run times (91 °F July daily normal high)
- Winter
- Space heaters (32 °F January daily normal low)
- 200-amp upgrade
- $1,800–$4,500 (Fixr, national)
- Electrician license
- North Carolina State Board of Examiners of Electrical Contractors
When does it trip?
| When it trips | What it can point to | Your move |
|---|---|---|
| When a space heater, hair dryer or microwave starts | Too much load on one circuit | Move the appliance to another circuit |
| A while after the AC or heat pump kicks on | A problem in the unit or its circuit | Leave it off after one reset; call an HVAC tech or electrician |
| Instantly, with nothing plugged in | A short or a wiring fault | Leave it off; call an electrician |
| In wet weather, on outdoor or bathroom outlets | Moisture at a GFCI-protected outlet | Keep it off until dry; if it continues, call |
| With buzzing, heat or a burning smell | Danger | Don't reset. Call an electrician; if there's smoke or fire, get out and call 911 |
Resetting it the right way
Unplug or switch off what's on that circuit. Find the breaker sitting between on and off, push it fully to off, then back to on. Plug things back one by one. One reset is the limit: a breaker that trips again is telling you something.
Want a price for your home? Call a local electrician for a written quote.
Phone line opening soonRaleigh's seasons and your panel
NWS daily normals for the Raleigh-Durham airport station show a 91 °F high through most of July and a 32 °F low on every January day (1991–2020). That means long cooling runs in summer, and in winter, space heaters added to whatever else the circuit carries. A panel that copes in spring can struggle at either end of the year.
If the panel needs work
Fixr says upgrading to 200-amp service typically costs $1,800 to $4,500, nationally. The City of Raleigh lists an electrical service upgrade among projects that require a permit but do not require plans. Check the electrician with the North Carolina State Board of Examiners of Electrical Contractors on its license search. More on the panel upgrade page.
What a repair usually costs
National ranges from cost publishers, not Raleigh quotes. The fault decides the price, so ask for it in writing before work starts.
| Job | National range | Source |
|---|---|---|
| Replacing a circuit breaker | $100 to $260 | HomeGuide |
When you call: 4 questions to ask
- What's your license number with the North Carolina State Board of Examiners of Electrical Contractors?
- Will you apply for the City of Raleigh permit for the service upgrade?
- Does Duke Energy or Wake Electric need to be involved, and who arranges it?
- Will the panel have room for a heat pump later?
A fair written quote shows the panel or parts, labor, the permit and inspection, and any extra wiring priced separately. Check any contractor's license on the state plumbing, heating and fire sprinkler board's license search before work starts.
What happens when you call
- You're connectedStraight to a local electrician that serves your area and takes calls like yours.
- You get a priceDescribe the problem, ask for a written quote and their license number. No obligation.
Common questions
Why does my breaker trip when I run a space heater?
A space heater draws a lot of power. Combined with other things on the same circuit, it can exceed what the breaker allows. Move it to a circuit with less on it.
Is it dangerous if a breaker keeps tripping?
The breaker is doing its job, but repeated trips mean something's wrong. If it trips again after one reset, or you notice heat or a burning smell, leave it off and call an electrician.
How much does a new panel cost?
Fixr says upgrading to 200-amp service typically costs $1,800 to $4,500, nationally.
Related guides
Sources
- National Weather Service Raleigh: KRDU 1991–2020 daily climate normals (Raleigh-Durham International Airport)
- Fixr: Electrical panel upgrade cost
- City of Raleigh Planning and Development: How to get a residential permit (updated July 13, 2026)
- Johnston County Inspections: licensing boards and contractor searches
Costs are typical ranges. Your quote depends on your home. Rules and rebates change; check the original source before you rely on a figure. Something wrong? Tell us via the contact on the Impressum page.