Test a second faucet first. Cold at one tap only points to that fixture; cold everywhere points to the water heater. For an electric heater, reset its breaker a single time. For a gas heater, do nothing at the burner or pilot; if there is any gas odor, leave and call 911 and Atmos Energy at 866.322.8667. Everything past those checks belongs to a plumber.

Key facts
- Is this an emergency?
- No, unless gas odor or a leaking tank comes with it.
- Can I sort it myself?
- A tripped breaker or a closed valve, yes. Burners, pilots and heating elements, no.
- Who do I need?
- A plumber licensed by the Texas State Board of Plumbing Examiners.
Is this an emergency?
Cold showers are miserable, not dangerous. Two things turn this page into a different one. Water pooling around the heater means go to water heater leaking. A gas smell means leave the house and, from a safe distance, call 911 and Atmos Energy's emergency number, 866.322.8667. For a home with a newborn or someone who needs hot water for care, treat it as a prompt repair and say so when you book.
Can I sort it myself?
Work through these in order. Each one is a look or a switch.
- Try another tap. Run hot water at a sink far from the first. If that one warms up, the fault is local to a single fixture.
- Think about recent use. Back-to-back showers plus laundry can drain a tank. Give it an hour and test again.
- Electric heater: breaker. Find the double breaker labelled water heater. If it has tripped, switch it off and on one time. If it trips again, leave it off.
- Gas heater: look, don't touch. Note whether you hear the burner or see a status light on the control, and pass that on to the plumber. Relighting and adjusting are not homeowner checks in this guide.
- Inlet valve. The valve on the cold pipe above the heater should be fully open, handle in line with the pipe.
- Scan for water. A damp base or rust trail changes the diagnosis.
Stop and call a pro when
- the breaker trips a second time;
- a gas heater has gone out and stays out;
- hot water runs rusty or smells odd;
- you get a short burst of hot, then cold, every time;
- the heater is leaking or making popping or rumbling sounds.
Want a price for your home? Call a local plumber for a written quote.
Phone line opening soonWho do I need?
A plumber, for both gas and electric tanks. The state body is the Texas State Board of Plumbing Examiners; use its Public License Search to confirm a license. An electric heater whose breaker keeps tripping may also need an electrician, and those are licensed separately through TDLR.
What a repair costs in Dallas is not something this guide can tell you, because no verified local figure is on file; a national range is below. If the plumber recommends replacement, the published national range for a tank-style gas heater is $1,000 to $2,700 installed (Fixr), and the City requires a permit for the swap. Details are on the replacement cost page.
Dallas details
| Item | What applies in Dallas |
|---|---|
| Gas utility | Atmos Energy (Mid-Tex Division); gas odor: 911 and 866.322.8667 |
| License to ask for | Plumbing license, Texas State Board of Plumbing Examiners |
| Permit for replacement | Required for water heater replacement (City of Dallas plumbing pamphlet, 2011, still posted) |
| Homestead owners | Exempted from the contractor requirement for plumbing work if you own, occupy and have homesteaded the home (City FAQ) |
| Replacement cost | $1,000 to $2,700, tank-style gas (national, Fixr) |
| Rebate on a new gas tank heater | Atmos Energy: $100, $150 or $200 by efficiency tier, program year July 1, 2026 to June 30, 2027 |
| Repair price | No local figure; national range below |
What a repair usually costs
National ranges from cost publishers, not Dallas quotes. The fault decides the price, so ask for it in writing before work starts.
| Job | National range | Source |
|---|---|---|
| Water heater repair | $150 to $750 | Fixr, updated Aug 2025 |
When you call: 4 questions to ask
- Water heater replacements need a permit in Dallas: who pulls it?
- Does a gas tank or tankless model you're quoting qualify for an Atmos Energy rebate?
- Is there a service-call fee, and is it applied to the repair?
- Can I see your Texas State Board of Plumbing Examiners license?
A fair written quote shows parts, labor, the permit, haul-away of the old heater, and written warranty terms. Check any contractor's license on the TDLR license search before work starts.
What happens when you call
- You're connectedStraight to a local plumber that serves your area and takes calls like yours.
- You get a priceDescribe the problem, ask for a written quote and their license number. No obligation.
Common questions
Why do I suddenly have no hot water?
For an electric heater, a tripped breaker is the first thing to check. For a gas heater the burner may have gone out, which is a plumber's job. Heavy use can also empty a tank for a while.
Who fixes a water heater in Dallas?
A plumber. Verify the license with the Texas State Board of Plumbing Examiners' Public License Search.
Should I relight the pilot myself?
This guide keeps homeowner checks away from pilots and gas controls. If you smell gas, leave and call 911 and Atmos Energy at 866.322.8667.
Is it cheaper to repair or replace a water heater?
There is no Dallas repair figure in this guide; a national range is on this page. Fixr's national range to replace a tank-style gas heater is $1,000 to $2,700 installed, so ask for both prices in writing.
Related guides
Sources
- Atmos Energy: Gas safety
- Atmos Energy: 2026 Dallas Annual Rate Review filing summary
- Texas State Board of Plumbing Examiners
- TSBPE: Public License Search
- TDLR: Electricians
- City of Dallas: How-to plumbing pamphlet (2011)
- City of Dallas: Building Inspection FAQs
- Fixr: Gas water heater cost
- Atmos Energy: Mid-Tex appliance rebate program
Costs are typical ranges. Your quote depends on your home. Rules and rebates change; check the original source before you rely on a figure. Something wrong? Tell us via the contact on the Impressum page.