Shut the cold inlet valve over the heater, then set the gas dial to Off or flip the heater's breaker. Water seeping from the shell itself points to a new heater; a drip at a joint or valve can often be fixed. A new water heater needs a Provo building permit, and ThermWise pays $100 to $350 in 2026 depending on type.
Key facts
- Step 1
- Close the cold supply valve
- Step 2
- Gas control to Off, or breaker off for electric
- Tank body leaking
- Usually means replacement
- Permit to replace
- Required (Provo City)
- ThermWise 2026
- $100 storage; $300 tankless; $350 condensing storage or hybrid
- Tank-style gas, installed
- $1,000–$2,700 (Fixr national average range)
- Shut off the incoming water. Follow the cold line down from the ceiling to the heater; its valve sits just above the heater. Turn it clockwise until it stops.
- Take away the heat source. On a gas model, set the dial on the gas valve to Off. On an electric model, flip its breaker. Any whiff of gas changes the plan: walk out, and once outside call Enbridge Gas Utah on 1-800-767-1689 and dial 911.
Cold supply closed and still dripping? Call a Provo plumber now, and keep going with the steps while you wait.
Phone line opening soonHave this ready when you call
- Your address
- Where the water is and whether the main is off
- When it started
- Locate the drip. Wipe the heater dry with a rag and wait a few minutes. Water may show up at the pipe joints overhead, at the pressure relief valve or its discharge pipe, at the hose spigot low on the side, or seeping from the shell.
- Save what's nearby. Shift stored items in the utility room, lay down old towels, and snap a few pictures for your records.
- Lower the water level, carefully. What's inside can scald. If you choose to drain, run a garden hose from the spigot to a floor drain only after the water has cooled.

Repair or replace?
| Where it leaks | Usual outcome |
|---|---|
| Pipe joint above the heater | Frequently fixable without a new heater |
| Pressure relief valve or its discharge pipe | A plumber should test why it opened |
| Spigot near the base | Frequently fixable |
| Shell or bottom seam rusted through | Plan on a new heater |
If it's replacement
Provo City's residential projects page lists water heater replacement among the jobs that require a building permit, so expect one on the quote. For budgeting, Fixr's tank-style row shows $1,000 to $2,700 (national average range). Enbridge Gas Utah's 2026 ThermWise form pays $100 for gas storage, $300 for tankless and $350 for condensing storage or a hybrid that reaches TE 90% or EF .90, in existing homes with one to three units. Utah plumbing contractors hold P200 or P201; check on DOPL license verification.
What a repair usually costs
National ranges from cost publishers, not Provo quotes. The fault decides the price, so ask for it in writing before work starts.
| Job | National range | Source |
|---|---|---|
| Water heater repair | $150 to $750 | Fixr, updated Aug 2025 |
When you call: 4 questions to ask
- Provo requires a building permit for a new water heater: will you pull it?
- Which 2026 ThermWise line does this heater qualify for?
- Do you hold a P200 or P201 license with DOPL?
- Is the problem on my side of the meter box or the city's?
A fair written quote shows the heater or repair, labor, the permit, removal of old equipment and the written warranty. Check any contractor's license on DOPL license verification before work starts.
What happens when you call
- You're connectedStraight to a local plumber that serves your area and takes calls like yours.
- You get a priceDescribe the problem, ask for a written quote and their license number. No obligation.
Want a price for your home? Call a local plumber for a written quote.
Phone line opening soonCommon questions
Is it safe to leave a leaking water heater running?
Better not. Shut the cold inlet valve and set the gas dial to Off, or flip the breaker if the heater is electric, until a plumber has looked at it.
Will a replacement heater in Provo need a permit?
It will. The Provo City page on residential projects says replacing water heaters requires a building permit.
What rebates are there for a new water heater in Provo?
Enbridge Gas Utah's 2026 ThermWise form pays $100 to $350 for qualifying gas water heaters in existing homes with one to three units.
Related guides
Sources
- Enbridge Gas: Smell gas? Safety steps for Utah, Wyoming and Idaho
- Provo City: Water heater, furnace and AC installation or replacement
- Fixr: Gas water heater cost
- Enbridge Gas Utah: 2026 ThermWise water heating rebate application
- Utah Division of Professional Licensing: Contractor license application
- Utah Division of Professional Licensing: License verification
Costs are typical ranges. Your quote depends on your home. Rules and rebates change; check the original source before you rely on a figure. Something wrong? Tell us via the contact on the Impressum page.