Local Repair FinderRaleigh home repair guide

A leaking water heater in Raleigh

Raleigh & Wake County · Reviewed November 2026 · Checked against 6 public sources

Close the cold water valve on top of the heater, then switch off its breaker (electric) or turn its gas control to off. A drip from a fitting can often be repaired; water from the tank itself usually means replacement. A new tank-style gas heater runs $1,000 to $2,700 nationally (Fixr). If you smell gas, leave first and call 911 and Enbridge Gas North Carolina at 1-877-776-2427.

Key facts

First
Cold water supply valve closed (or the house main)
Second
Electric: breaker off. Gas: control to off
Gas smell
Leave; call 911 and Enbridge Gas North Carolina, 1-877-776-2427
Replacement, tank-style gas
$1,000–$2,700 (national, Fixr)
Permit
City lists replacement as needing one; state exemption has conditions
License
North Carolina State Board of Examiners of Plumbing, Heating and Fire Sprinkler Contractors
  1. Shut off the water to the heater. The cold supply valve is on the pipe going into the top. If it won't turn, close the main shutoff for the house.
  2. Turn off the energy. Electric heater: switch off its breaker at the panel. Gas heater: turn the control knob to off. If you smell gas at any point, stop, leave the house and warn others, then from a safe place call 911 and Enbridge Gas North Carolina at 1-877-776-2427.
  3. Supply closed and the heater switched off, but water still pooling? Call a plumber now and keep going with the steps while you wait.

    Phone line opening soon

    Have this ready when you call

    • Your address
    • Where the water is and whether the main is off
    • When it started
  4. Contain the water. Towels, a wet vac, a bucket under any drip. Move boxes and anything stored nearby.
  5. Find where it's coming from. Look at the fittings on top, the relief valve and its discharge pipe, and the drain valve near the bottom. Water seeping from the tank body or the base is the harder case.
  6. Photograph it. Take pictures of the heater's label, the leak and any damage before cleanup, for your insurer and the plumber.
Water pooling in a drain pan around the base of a water heater

Repair or replace: a quick sort

Where the water isWhat it often means
A fitting or pipe on topA connection a plumber may be able to tighten or replace
The relief valve or its pipeThe valve may be faulty, or pressure or temperature may be too high; have it checked, don't plug it
The drain valve at the bottomOften a valve problem rather than the tank
The tank shell or under the baseUsually a tank that has failed and needs replacing

If it's time for a new heater

Fixr's national figure for a tank-style gas water heater is $1,000 to $2,700. There's no Raleigh-only price in this guide's sources. On permits, the City of Raleigh lists water heater replacement among projects that require a permit but do not require plans, while G.S. 160D-1110(a) waives the permit for certain like-for-like swaps in one- and two-family homes, done by a licensed person, when every condition in the statute is met. The replacement page quotes both in full. Ask the City which applies to you.

Check the plumber on the state board search for the North Carolina State Board of Examiners of Plumbing, Heating and Fire Sprinkler Contractors.

What a repair usually costs

National ranges from cost publishers, not Raleigh quotes. The fault decides the price, so ask for it in writing before work starts.

JobNational rangeSource
Water heater repair$150 to $750Fixr, updated Aug 2025

When you call: 4 questions to ask

  1. The City lists water heater replacement as needing a permit: will you apply, or are you relying on the G.S. 160D-1110(a) exemption, and why?
  2. Is this leak on my side of the property line or the City's?
  3. For a gas heater, will you leak test the gas piping when you're done?
  4. Is the service-call fee credited if I go ahead?

A fair written quote shows the heater or parts, labor, any permit, haul-away of the old tank and the written warranty. Check any contractor's license on the state plumbing, heating and fire sprinkler board's license search before work starts.

What happens when you call

  1. You're connectedStraight to a local plumber that serves your area and takes calls like yours.
  2. You get a priceDescribe the problem, ask for a written quote and their license number. No obligation.

Want a price for your home? Call a local plumber for a written quote.

Phone line opening soon

Common questions

Is a leaking water heater an emergency?

It can turn into one. A drip from a fitting can usually wait for a plumber once the supply is off, but a tank leaking from its body can release a lot of water. Shut off the water and the energy either way.

How do I turn off a gas water heater?

Turn the control knob to off and close the cold water valve on top. If you smell gas, leave instead, and from a safe place call 911 and Enbridge Gas North Carolina at 1-877-776-2427.

Do I need a permit to replace a leaking water heater in Raleigh?

The City lists water heater replacement as needing a permit. G.S. 160D-1110(a) has a conditional exemption for some like-for-like swaps. Confirm with City of Raleigh Planning and Development.

Related guides

Sources

  1. Enbridge Gas North Carolina: Report a gas emergency
  2. Fixr: Gas water heater cost
  3. City of Raleigh Planning and Development: How to get a residential permit (updated July 13, 2026)
  4. North Carolina General Statutes: G.S. 160D-1110
  5. State Board of Examiners of Plumbing, Heating and Fire Sprinkler Contractors: Consumer awareness
  6. Johnston County Inspections: licensing boards and contractor searches

Costs are typical ranges. Your quote depends on your home. Rules and rebates change; check the original source before you rely on a figure. Something wrong? Tell us via the contact on the Impressum page.