Local Repair FinderDenver home repair guide

Furnace not working in Denver: rule these out first

Denver & the metro area · Reviewed November 2026 · Checked against 10 public sources

Most no-heat calls start with something small: a thermostat left on Cool, a filter packed with dust, a furnace switch knocked off, or a breaker that tripped. Rule those out, and if the vents stay cold, stop there and bring in a heating contractor. Denver's normal January low is 18.7 °F, so protect your pipes while you wait. A gas smell means leave first.

Key facts

Rule out first
Thermostat mode, batteries, filter, furnace switch, breaker, outdoor vent pipes
Gas odor
Leave, then Xcel Energy 1-800-895-2999; 911 if life-threatening
Whole house dark
Xcel Energy 1-800-895-1999 (residential)
Certificate to ask about
Denver mechanical supervisor certificate, such as “Heating, Ventilating, A/C – Residential Only”
If it has to be replaced
Gas furnace installed: $3,800–$10,000 (national, Fixr)
Xcel Energy rebate (2026)
$225 for a 95%+ AFUE gas furnace replacing a non-condensing one
Normal January low
18.7 °F (National Weather Service monthly summary)

Rule out the simple things

  1. Set the thermostat to Heat: a mode left on Cool or Off after a warm spell keeps the burner from ever being asked to start.
  2. Push the setpoint a few degrees past the room reading: the furnace only fires when the target is higher than the air around the thermostat.
  3. Put new batteries in a blank thermostat: a dead screen cannot send a signal, however healthy the furnace is.
  4. Slide out the air filter: a filter matted with dust starves the furnace of air, it overheats, and a safety control shuts the flame down.
  5. Flip the furnace switch back up: the on-off switch beside the unit looks like a light switch and gets knocked down by boxes, brooms and elbows.
  6. Five checks done and the vents are still cold? Ring a local heating company now, then finish the list.

    Phone line opening soon

    Have this ready when you call

    • Your address
    • What the system is doing (no heat, no cooling, a noise, a leak)
    • Roughly how old the unit is
  7. Reset a tripped breaker one time only: a single trip can be a fluke, while a second trip points to a fault that needs a technician.
  8. Look at the plastic vent pipes on the outside wall: drifted snow or ice over the openings makes many furnaces lock out; brush it away by hand and leave the pipes themselves alone.
  9. Open the registers and clear the return grille: closed vents and a couch across the return can leave rooms cold even with the burner running.
Basement furnace with its front panel removed

Signs it is not simple

  • You smell gas anywhere in the house. Skip every check and go outside.
  • A carbon monoxide alarm sounds. Get everyone into fresh air and call 911.
  • The breaker trips again after your one reset.
  • The furnace starts, runs for a minute or two, shuts off and repeats.
  • There is a burning smell, soot, or scorching on or around the cabinet.
  • Water is collecting on the floor under the furnace.
  • Everything on the list checks out and the air from the vents is still cool.

Past this point the work means taking covers off, testing live parts or touching the gas train. Leave the gas valve, the pilot and the inside of the cabinet to someone who does it for a living.

Who does what in Denver

Xcel Energy handles the gas and the power. It is the natural gas and electric utility for Denver. For a gas odor, Xcel Energy's instructions are to leave home immediately and not to turn any electrical device on or off, use a garage door opener, or use any phone until you are outside and away. From there, call Xcel Energy at 1-800-895-2999, and call 911. When the lights are out as well as the heat, the residential line in Xcel's outage release is 1-800-895-1999.

A heating contractor handles the furnace. Denver's Contractor Licensing office issues mechanical supervisor certificates, among them “Heating, Ventilating, A/C – Residential Only” and “Heating and Ventilating Class B Supervisor – Residential Only”. Ask the company which certificate holder stands behind the job. Colorado's DORA lookup covers plumbers and electricians. Denver's page offers no public lookup; ask the company for its Denver certificate number and check with Denver Contractor Licensing at (720) 865-2770.

The city handles the permit. Denver's quick permits page lists “Forced air heating systems” among the single-family and duplex work that can be issued as a quick permit, which is a trade permit with no plan review. That matters when a repair turns into a replacement. This guide has no city statement on permits for a part swap; Community Planning and Development answers general questions at 720-865-2700.

What it may cost. This guide has no Denver figure for a furnace repair visit. If the verdict is replacement, Fixr's national figure for an installed natural gas furnace is $3,800 to $10,000, and it is a national number, not a local one. Xcel Energy's 2026 rebate summary lists $225 for a 95%+ AFUE gas furnace that replaces a non-condensing furnace. More detail sits on the furnace replacement cost page and the rebates page.

Why the clock matters here. National Weather Service monthly summaries for Denver give a normal January low of 18.7 °F. An unheated house on a night like that puts water lines at risk, so open the cabinet doors under sinks, let a faucet drip, and keep the frozen pipes steps handy. The Capitol's mile-high step is marked at 5,280 feet; when new gas equipment is quoted, ask how it will be set up for the altitude.

What a repair usually costs

National ranges from cost publishers, not Denver quotes. The fault decides the price, so ask for it in writing before work starts.

JobNational rangeSource
Furnace repair$349 to $650Fixr, updated Aug 2025

When you call: 4 questions to ask

  1. Which Denver mechanical supervisor certificate covers this job, and who pulls the quick permit?
  2. Is the new furnace 95% AFUE or better, so it qualifies for Xcel Energy's rebate?
  3. For a heat pump: will you claim the Colorado Heat Pump Tax Credit and show the discount on my invoice?
  4. Will you size it with a load calculation for our altitude and winters?

A fair written quote shows equipment model and efficiency, the permit, rebate and tax-credit paperwork, and parts and labor warranty. Check any contractor's license on the DORA license lookup before work starts.

What happens when you call

  1. You're connectedStraight to a local heating & cooling pro that serves your area and takes calls like yours.
  2. You get a priceDescribe the problem, ask for a written quote and their license number. No obligation.

Want a price for your home? Call a local heating & cooling pro for a written quote.

Phone line opening soon

Common questions

Why is my furnace running but blowing cold air?

Common simple causes are a thermostat fan set to On instead of Auto, a clogged filter that makes the furnace overheat and shut its burner off, or a tripped breaker. If the air is still cool after those checks, turn the system off and call a heating contractor.

Who do I call when the heat goes out in Denver?

A heating contractor for the furnace itself. Call Xcel Energy at 1-800-895-2999 from outside if you smell gas, or 1-800-895-1999 if the power is out at a home address. Use 911 when anyone is in danger.

How much does furnace repair cost in Denver?

This guide has no verified Denver repair price. Besides the national repair range on this page, the other checked figure is Fixr's national figure for a new installed gas furnace, $3,800 to $10,000. Ask for the repair price in writing before work starts.

Does replacing a furnace in Denver need a permit?

Denver lists forced air heating systems among the work on single-family and duplex homes that can be issued as a quick permit, meaning no plan review. Ask the contractor to show that the permit is part of the quote.

Related guides

Sources

  1. National Weather Service Denver/Boulder: January 2026 monthly weather summary
  2. Xcel Energy newsroom: gas safety and cold weather release, January 2026
  3. Xcel Energy newsroom: outage preparation release, December 2025
  4. City and County of Denver: Denver-Xcel partnership
  5. Denver Contractor Licensing: Mechanical supervisor certificates
  6. Denver Community Planning and Development: Quick permits
  7. Denver Community Planning and Development: Contact us
  8. Fixr: Furnace cost (national)
  9. Xcel Energy: 2026 Colorado Residential Rebate Summary
  10. State of Colorado: Colorado State Capitol

Costs are typical ranges. Your quote depends on your home. Rules and rebates change; check the original source before you rely on a figure. Something wrong? Tell us via the contact on the Impressum page.